Bathroom cabinet acceptance key construction quality

In the home decoration, no matter which aspect of the decoration, construction quality inspection and acceptance is very critical, three-point materials, seven points installation. Construction is the key to determining the quality of the project. Below, we look at how to carry out the quality inspection of the bathroom cabinet construction.

Construction quality inspection should be close

The contact mentioned here should be tight. It means that the distance between the table and the wall should be sealed. Otherwise, it is easy to store water between the cabinet and the wall. Under normal circumstances, the gap between the two is within 3mm. A simple sealing process is all right.

Construction quality inspection, the second edge should be firm

The bathroom cabinet is located in a special place and requires higher rigor. When the bathroom cabinet is constructed, the acceptance depends on whether the sealing edge is firm, including the box edge sealing and the door panel sealing. Edge sealing is critical to the protection of the bathroom cabinet. Moreover, it should be noted that the edge of the board must be smooth and smooth, and there must be no degumming, bulging, pit, missing and tearing. The trimming must be flat without corners; the width of the edge cannot exceed the thickness of the sheet.

Construction quality inspection three flexibility check

Finally, for all the moving parts of the bathroom cabinet, it is best to check the flexibility or the weight, whether the distance between the door and the frame and the drawer is in compliance with the regulations, and whether the movement is flexible and frictionless. Our requirement is that all door panels and drawers are smoothly opened and closed without collision and rubbing.

The fixed part of the cabinet should pay attention to the height, too high and too low to be convenient to use; the active parts such as drawers, doors, etc., the drawer rails can be moved in and out with reasonable weight, smooth and no noise; the door panel can be opened freely without the door touching the door. The load-bearing parts are the parts where heavy objects are placed, such as countertops, shelves, etc. It is necessary to pay attention to the fact that the surface color has no obvious color difference, the platen has fine workmanship, smooth hand feeling and smoothness. In addition, attention should be paid to the small details of cracks and edge seals. Cracks are cracks that cross each other with adjacent material faces, and edge seals are methods that use other materials to close and decorate the sides of the plate members. Such as finishing method, edging method, edge sealing method and edging method.

Construction quality check whether there are gaps in the four corner stitching

For the acceptance of construction quality, we have been emphasizing the rigor, of course, we can not ignore the gap of the corner stitching. The gap of the corner stitching should be done with the edge sealing, and there must be no obvious material color difference and adjacent two pieces of the matching part. The moisture content difference must be within 2%.

Therefore, check the construction quality of the bathroom cabinet from these four aspects, and carefully check the quality of the construction as much as possible.