In the home renovation, the floor heating is a hidden project. The main ground is a radiator, and the entire floor is radiated uniformly to heat the entire floor. The ground heat is transmitted through the ground's own heat storage and upward heat radiation pattern to achieve heating. Next, Xiaobian introduced the floor heating standards and the floor heating laying process.

Floor heating standards

1. When laying floor heating, pay attention to the formation of the ground. The basic standard is an error range of ≤ 3 mm per 2 m; the moisture content of the ground is ≤ 18%; and the air humidity, the standard should be 45% to 85%. If there is no compliance, the customer should be prompted to use the humidifier or window ventilation method to balance the air humidity during the future use.

2. Before laying the floor heating, in order to avoid the destruction of the floor heating pipes, some ground parts cannot be stapled. Therefore, for pre-embedded pipelines, customers should be asked in advance and properly identified.

3, floor heating to pavement specifications according to the specification requirements, for the more humid ground or floor heating, should be on the ground pavement with a layer of plastic film or reflective film, but also sealed with waterproof tape, and then shop 2mm thick ground pad. This layer of plastic film is very important, otherwise it is difficult to achieve moisture-proof effect.

4. Laying should be carried out in accordance with the standard rules so as to ensure that geothermal heat is at a reasonable temperature. According to JGJ142-2004 Technical Requirements for Radiant Floor Heating, the maximum temperature of direct contact with the floor should be less than 42°C, and the general control at 38°C is ideal. . However, part of the water is warm and the temperature far exceeds this standard. Excessive geothermal temperatures will cause detackification of the tape at the joints of the floor mats, causing the moisture to smash. In order to eliminate this problem, we must control the warm water temperature or choose a better quality floor.

Floor heating process

1, laying a good floor heating, shape, color are more beautiful, laps around looks very neat, and these pipes is a pass to the end, there is no break in place.

2, for the pipeline is not how you want to shop on how to shop, should be laid against the steel mesh laying, so that the effect of paving out is good.

3, when laying in the turning place, there are still provisions, we must measure a good distance, and then set a good position, the tube fixed up, this laying is more standardized.

4. The places laid in parallel are also strictly regulated so that the ground can be evenly heated, and the white plastic tie next to it is used to fix the coils one by one.

5, to warm the pipeline to choose good quality, if accidentally stepped on, it can also be a good restoration of the original state.

6, when heating, the water is divided into two separate rooms, in order not to move the coil, the construction staff to use black plastic tube card to fix, so that the tube can maintain a certain distance.

7, the heating control valve, can be divided into several ways to transport warm water to various areas, while the black pipe looks very clean and tidy, convenient for owners to understand the heating situation.

8, although the entire host is not hung up, but the construction staff has marked the interface of each location, ready to do a good job, to the time installed is relatively simple.

Editor's summary: The standards for floor heating and the laying of floor heating are introduced here. I hope to help everyone. If you want to know more related information, you can pay attention to this website information.

Warm floor brand warm floor heating standards