Solve the problem of installation and maintenance of smart hotel locks

1. For hotels or decoration companies, experienced woodworkers should be hired to install the door locks, and according to the opening drawings of the hotel locks, the holes, chisel support sockets, lock plates and lock box holes, check the locks Configure the parts to be ready for installation.

2. Check the hole that is to be cut on the door, and install it according to the instructions in the product. If the switch control is not flexible or can not be switched after installation, please check the lock box hole on the door post immediately. If it is right, if it can't be solved, you should consult the dealer or enterprise technical service department and the after-sales department in time to solve the problem.

3. If there is no problem in installing the door lock for the opening, if your door panel needs to be painted, then you need to remove the door lock and wait for the lock after two or three days after the paint is dry, so as to avoid the pollution of the lock on the paint. Preventing its appearance or paint from entering the lock body, causing gelatinization, affecting the operation of the mechanical control mechanism, while the paint gas that has not been dried has a corrosive effect on the door lock, accelerates the aging of the lock product surface and damages the circuit board, and reduces the use of the hotel lock. life.

Second, the intelligent lock daily use knowledge

1. It is necessary to keep the mechanical control part of the lock running naturally. It is necessary to use lubricant to ensure smooth movement and reduce mechanical friction. It is best to check it half a year. At the same time, it is necessary to pay attention to whether the lock screw is loose or not to determine the door lock. It is strong and can also avoid damage to the door itself.

2, hotel locks or other electronic smart locks are used to complete the switch door with the induction card, rarely use the key to control the lock, it is recommended to use the mechanical key to switch the door lock for half a year or a year, if it is found that there is no plug Smooth, then it is best to rub the toner or other non-solidifying lubricant on the mechanical sales for multiple insertions and removals.

3. Check the gap between the lock body and the lock frequently. The ideal clearance is 1.5MM-2.5MM. If the lock tongue and the lock buckle are found to be rubbed or the lock buckle is loose, check whether the lock is not strong.