Brief introduction of automatic dispenser and debugging method of automatic dispenser

Automatic dispenser is a professional equipment that replaces manual dispensing, and has a wide influence in the industry. Dispensing is required in many places in industrial production. Traditional dispensing methods are done manually by workers. With the rapid development of automation technology, manual dispensing is gradually being dispensed because it cannot meet the needs of industry Machine replacement. And the use of this professional equipment first requires personnel to debug, so what is the debugging method of the automatic dispenser?

 

Brief introduction of automatic dispenser

 

With the rapid development of automation technology, manual dispensing has been far from meeting industrial requirements. Manual dispensing has the disadvantages of complex operation, slow speed, low accuracy, error-prone, and the inability to carry out operations of complex graphics, and even the realization of production automation. The market requires a device with high speed, high efficiency and high precision. Therefore, a fully automatic dispensing robot appeared.

In the case of technology is the first productivity, the emergence of fully automatic dispensing robots has brought unprecedented opportunities and development to the dispensing industry. In order to communicate with dispensing robots simply and conveniently, people communicate their ideas to the robots, and make the robots move in accordance with human will and the requirements of the dispensing process, they invented a teaching programmer system. This teaching programmer can easily control the dispensing robot, send various motion instructions, and execute various graphics of dispensing

 

　 Debugging method of automatic dispenser

 

1. Put the syringe filled with glue into the syringe holder and fix it. For example, to install AB glue, connect A glue and B glue from the pressure barrel to the glue guns A and B inlets respectively. The A and B glues are mixed through the three-way to the mixing tube. It only needs to control the pressure bar to control the glue on and off. It consists of a series of left and right rotating blades arranged vertically in the casing. A and B glue are continuously cut and superimposed into a uniform mixture when passing through the mixing tube to ensure the amount of glue accurate.

2. Connect the gas valve, connect the dispensing controller port of the dispenser to the syringe through the air tube, and connect the syringe valve to the AIRIN of the dispensing controller, and connect the cable between the dispenser and the dispensing controller line.

3. Connect the dispensing interface of the dispenser to the signal input interface of the dispensing controller via a cable, and connect the foot pedal to the operating interface of the dispenser to control the operation of the dispenser. Connect the Z-axis connection cable plug to the Z-axis of the dispenser. If the dispenser controller used is the same as the connector model of the dispenser, you can see the connection ports for dispensing and operation of the dispenser according to the number of cores of the connector. Two-core dispensing and three-core operation.

4. Select the handheld programmer to the interface on the left side of the dispenser through the serial cable. If the dispenser controller used is not the same as the connector model on the back of the dispenser, the cable can be wired according to the instructions of the dispenser controller. Preparation and connection.

The above is the relevant knowledge content about the debugging method of automatic dispenser and the introduction of automatic dispenser. Dispensing is required in many places in production, and the requirements are getting stricter. Such as integrated circuits, semiconductor packaging, printed circuit boards, color LCD screens, electronic components, electronic parts and automotive parts, etc.