How to make plastic hangers

Mainly: (1) The tolerance of the jaw is at most 0.05.. (2) The thimble should be positioned well... The position of the thimble should be averaged. . Hanger molds are usually 1 out 2... thimbles together 18 sticks. The front template material is 718... The whole board is 718. The back mold is also 718.. It can be customized...because this mold is a flat plane ...in this way, the flash of the mold is also less.. Resilience.. Speaking of the product requirements.. Clamping mouth..0.05.. Please do not underestimate.. The highest requirements of the hanger mold is this small jaw. A lot of masters who have been working on molds for more than ten years are not sure... I think that flying molds can change the jaws to a small size.... This is wrong.. Big mistakes... and the hanger mold must be positioned. lock. . Waterway hanger moulds are usually pp materials.. It is also considered a daily necessities, so the batch size is relatively large~~ So the cycle of the squad is very important. If you want to speed up the friends, you can spend more renminbi.. add a ace In the back of the back mold, add a board.. Then do it in the back mold. The water tower. The water tower should run around the product. The cooling rate is super fast~~~~ The above is just how to do it.. .. and speed up production....
hope this helps. . .

PU Rod is divided into polyester and polyether. Polyether Pu Rod is superior to polyester type in terms of resilience, evaporability, low temperature performance, impact strength, heat accumulation, water resistance and mold resistance.Low viscosity and easy operation.Polyester PU rod has high viscosity and difficult operation, but mechanical strength, tensile strength, tear strength, sliding friction, oil resistance, heat aging, metal adhesion, solvent resistance and oxidation resistance are better than polyether PU rod.

PU rod is widely used in metallurgy, mining, petroleum, building materials, cushions, blocks, springs, suitable for all kinds of metal pipe punching die, reducing the friction of general mechanical equipment, buffering shock absorption, is ideal Mold spring.

Product	Diameter(mm)	Length(mm)	Color	Density(g/cmÂ³)
PU ROD	20-200	1000	nature/tea color	1.15
PU ROD	16-350	300/500	nature/tea color	1.15

PU Rod

Pu Rod ,Extruded Pp Rod ,Polyurethane Rod,Polyurethane Rubber Rod

Shenzhen Anheda Plastic Products Co.,Ltd , http://www.ahdplastic.com