Bowl Mill,Diamond Bowl Grinding,Diamond Grinding Stone,Diamond Grinding Tool Hengshi Diamond Tools CO.,LTD , https://www.ryomaltools.com
Check the oil level in the crankcase. If it is insufficient, add it to the marking line on the oil scale. If the oil is insufficient or the oil quality is not good, the oil shaft, connecting rod, piston, valve, etc. of the gasoline engine will be seriously worn. It will cause major accidents and special attention should be paid to this point.
The water-absorbing rubber hose must not be bent excessively and heavy objects should be placed on it to prevent it from being broken or flattened. The sealing gaskets in the water-absorbing hose fittings must not be lost or damaged, otherwise it will cause difficulties in diverting water, or even water diversion.
Check whether the governor connection parts are flexible.
Eliminates discovered faults and abnormalities in a timely manner.
Hand-carried mobile fire pump maintenance <br> <br> Check the air filter element, the elimination of debris, keep the filter clean. Check fastener bolts and allow no loosening. Check that the oil level is within the specified range. Check the vane pump oil cup for oil.
The air filter element must be cleaned after the start-up time reaches 25 hours.
For every 50 hours of operation, the spark plug must be removed, the gap checked, and the gap adjusted to within 0.6-0.7mm. Check the heat sink and remove dirt from the heat sink. Replace the oil, loosen the oil drain bolt, tilt the engine slightly, allow the oil to flow out slowly, add clean oil, and wait until the oil stays dry, tighten the oil drain bolt, and add clean oil from the oil filling port to the specified height. (Note: The new machine has been used for 5 hours cumulatively. The engine oil must be changed once. The one-time addition is 1.1 liters.)
For every 100 hours of operation, the fuel tank and the fuel filter must be cleaned. Open the fuel tank cap, remove the filter net, gently scrub with a brush, remove the fuel tank, clean the interior of the fuel tank, remove the internal dirt and moisture, install the fuel tank, put the filter in the injection port to add new fuel, Until the red baseline.
Every two years, check the aging of the fuel pipe. If it is found that there is aging, hardening or cracking, it must be replaced. Replace the joint and tighten the joint to check for oil leakage.
Hand-carried mobile fire pump maintenance <br> <br> hand-carried mobile fire pump must be kept clean and intact, should be removed after each use external dust, oil. Check whether the parts are complete, whether the fastening parts are tight and trim at any time.