Specific operating procedures for the radial drilling machine: 1. The operator must strictly abide by the four requirements and five disciplines of the maintenance equipment, and strictly prohibit the use of equipment. 2. Before driving, you must carefully check according to the inspection point and lubricate according to the lubrication map. 3. When parking for more than eight hours and then start the equipment, it should be rotated at a low speed for 3 to 5 minutes to confirm that the lubrication system is unblocked, and the various departments are working normally and then start working. 4. Before the work, the rocker arm and the headstock must be adjusted to the required position, and the parts should be clamped before working. 5, the loading of the workpiece must be firm and reliable, when drilling through holes, should be placed on the bottom pad in advance. 6. Before work, according to the working material, tool diameter and machining method, determine the spindle's revolutions per minute according to the adjustment disc table on the spindle box. 7. When drilling with a motorized feed, it should be changed to manual feed when it is close to drilling. 8. Before the work, according to the working material and the diameter of the drill, select the feed per revolution of the spindle according to the adjustment disc table on the spindle box. 9. When adjusting the drilling depth, first move the spindle by hand to lock the drill to the depth of the motorized feed handle. 10. Always clean iron scraps when drilling deep holes. 11. During the work, the equipment should be checked frequently and the working condition of the lubrication system. If the operation and lubrication work are poor, the equipment should be stopped. Pay attention to the sound. 12. Stop the spindle and change the feed rate during work. 13. Always check the iron scraps and oil on the workbench and rails, screw bars, etc., and keep the surrounding environment clean. 14. Do not stop before the drill bit is retracted from the workpiece during the drilling process. When tapping, use the reversible coupling to make the spindle reverse, but care must be taken to place the handle in the fixing groove. 15. Always check the tightening of the drill to prevent loosening. 16. It is forbidden for the operator to leave or trust the person to start the equipment. 17. In the work, the overload insurance combined with the automatic disengagement stop feed must immediately eliminate the cause of the overload. 18. Non-electricians are not allowed to open the electrical box door. 19. Before leaving work, each handle must be placed in the non-working position, the headstock is moved to the position close to the main column, the rocker arm is lowered to the lower part, and the power is cut off. Steel Casters,Steel Caster Wheels,Swivel Caster Wheels,Stainless Steel Caster JIANGSU SHENPAI CASTER CO., LTD , https://www.shenpaicaster.com