What are the installation precautions for toughened glass doors?

Tempered glass doors not only have a strong resistance to attack, but also have a strong wind pressure resistance, so they are widely used. So, what are the precautions for the installation of toughened glass doors ? Let's let Xiaobian introduce seven precautions for the installation of tempered glass doors!

Seven Considerations for Installation of Tempered Glass Doors

1. Before we install the tempered glass door, we must first test the vertical height and beam height of the main support of the steel analysis frame. We must pay particular attention to the repeated inspection of the hole position of the device. Finally, the number of suckers is determined according to the glass component and the sucker specifications, and the glass and the suction cup are cleaned to prevent the adsorption from being strong.

2. Next, we can install the glass. First, the support head is installed, and then the device for supporting the steel jaws needs to use a torque wrench. The torque size must be determined according to the detailed specification of the support system. Keep hanging on the two docking joints.

3. The pad should be included in the human tank first, and then the glass should be slowly incorporated into the human tank. This can prevent the glass from oscillating in the tank and form a crack. At least 2 blocks should be placed under each glass, and the length of the block. Cannot be less than 100mm.

4. After the glass device is finished, the orientation of the glass and the size of the crack should be adjusted first. The deviation must not exceed 2mm. The fasteners are then fastened and the glass is fixed.

5. The flatness test shall be carried out on every two floors of the installation. The deviation between the flatness shall not exceed four millimeters, and it shall be verified that there is no error at all until the sealing is completed.

6, when using the motor, in order to allow the glass does not produce deflection or rolling. The suction cup must be positioned and slightly biased slightly above the center of the glass to lift the glass two to three centimeters. This will make it easier to detect if the suction cups are holding the glass.

7. When installing the glass to a designated location, everyone must install it carefully to prevent the glass from colliding with the steel frame during landing and damage. After the first glass reaches the designated position, it needs to detect the vertical angle next to the glass. After the glass is in position, it only needs to check if the upper and lower slits are equal.

The above is all about the seven matters concerning the installation of toughened glass doors , and I hope to help everyone. If you want to know more relevant knowledge, you can continue to pay attention to the relevant information of this website. Xiao Bian will bring more exciting content for everyone.