The three-coordinate measuring instrument is a high-precision instrument. The correct use of the three-coordinate measuring instrument is related to the length of the life of the three-coordinate measuring instrument. It is related to whether the three-coordinate measuring instrument can accurately measure the workpiece. The following describes the three-coordinates. The use of the measuring instrument The three-coordinate measuring instrument is a high-precision instrument. The correct use of the three-coordinate measuring instrument is related to the length of the life of the three-coordinate measuring instrument, and it is related to whether the three-coordinate measuring instrument can accurately measure the workpiece. Here's how to use the CMM:
Biomass Gasifier is a reactor equipment where the Biomass material react with air and water at high temperature. Biomass Gasifier can convert biomass material into fuel gas through complex physical changes and chemical reactions. Our Biomass gasifier is circulating fluidized bed gasifier system possess.
1. The first step is to view the part drawings, understand the measurement requirements and methods, plan the test plan or call up the test program.
2. During the process of lifting and placing the parts to be tested, special attention should be paid to the safety regulations of the crane to protect the machine and parts from damage. The parts are placed in a position where the detection is easy and the Abbe error is the smallest and fixed.
3. Install the probe and probe accessory according to the measurement scheme. Press the “Emergency Stop†button to proceed, and pay attention to the light and easy to use. After the replacement, try to test whether the probe protection function is normal.
4. During the measurement process, the operator should concentrate on the operation. When running the program for the first time, pay attention to the deceleration operation and determine the correct speed before using the normal speed.
5. Once there is abnormal situation, immediately press the “emergency stop†button to protect the site, find out the cause, then continue to operate or notify the maintenance personnel to repair.
6. After the test is completed, archive the measurement program and program operation parameters and probe configuration.
7. Disassemble (replace) the parts and clean the table.
8. The three-coordinate measuring instrument should be properly cleaned after use, and the post-maintenance is also very important.
Source: [Xi'an Edwards Measuring Equipment Co., Ltd.] (http://) Original address: http://, please indicate the source.
Http://news.chinawj.com.cn Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn
Biomass Gasifier
Biomass Gasifier,Biomass Waste Gasification Plant,Biomass Gas,Biomass Gasifier System
Henan Dianyan New EnergyTechnology Co. Ltd , https://www.cngasifier.com