Bicycle bearing, drive parts, sludge removal method

Source: Bearing network time: 2014-02-01

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

Bicycle bearing, drive parts, sludge removal method summary: bicycle six rolling bearings drive sludge timing to adopt fire oil eradication using chemical scooping chemical detergent oily lotion main components surfactant chemical eradication using water bleaching dry drying shovel dewatering is divided into two The method is slightly different. The bearing is removed. The bicycle bearing is rolled. The rolling bearing is disassembled. The clean paper cloth parts are muddy dirt. The parts of the steel bowl are front and rear. The roller and the fire oil bicycle have more time for the six rolling bearings and the driving parts to be stained with the sludge. The fire oil removing method can be adopted. Chemical scooping can also be used. Chemical scavengers are preferred for oily scooping agents; the main components are surfactants. After chemical scooping; they are also rinsed with water. When removing sludge, they should be divided into two; The method is slightly different.
1. Removal of bearings:
Before removing the bicycle bearing; first disassemble the rolling bearing; wipe off the sludge and dirt on the parts with clean paper or cloth; then place these parts such as steel bowls, steel blocks, front and rear axle rolls, etc.; Soak in the scavenger. After soaking for a while, use a brush (old toothbrush can also) to wash the parts.
2. Removal of bicycle drive parts:
Remove the chain first; wipe off the sludge and dirt on the chain, sprocket, flywheel and other parts with clean paper or cloth; then put these parts in the fire oil or chemical scavenger soaking. Chain soaking time is longer; make the sludge The dust is dissolved; then the chain is changed; the chain is cleaned with a brush; the inner pieces of the chain, the inner side of the outer piece and the fine sand on the roller are more difficult to remove; the cloth head is stuffed inside. Rub the chain one by one; then clean the chain. The sprocket and flywheel should be removed with fire oil; then wipe clean with a cloth. After eradication; add lubricating oil (oil or grease).
Bearing and drive parts can be removed by the following scavenger formulations: 38% sodium alkylbenzene sulfonate, 9% coconut oxyethylene (8) ether, 2.5% sodium tripolyphosphate and 50.5% water. When using this agent; can be diluted with water.

Recommend to friends comments close window

Bearing related knowledge

Analysis: Common Terms and Definitions for Descriptive Bearings in Stainless Steel Deep Groove Ball Bearings (15)
Common terms for bearings (1)
The difference between the fine bearing and the ordinary bearing is a detailed analysis of the skills of the initiating machine sliding bearing (3)

This article links to http://
Please indicate China Bearing Network http://

Previous:The ultimate axial bearing of the bearing can be analyzed. The next section: Analysis and treatment of the oscillation of the turbine with gearbox

Hydrostatic Testing Machine

Full hydraulic hydrostatic testing machine for steel diameter from Ï†25mm to Ï†3600mm, is one of main product in our company, which is used for pressure test of steel pipe and stress elimination in pipe body.

Hydrostatic Tester Machine,Hydrostatic Testing Machine,Hydro Tester,Hydrostatic Tester

Taiyaun JDS Machinery And Equipment Co., Ltd. , https://www.jdsmachine.com