T Section Steel,Mild Steel T Profile,Carbon Steel T Beam,Hot Rolled Steel T Profile Shandong Xinsuju Steel Co.,Ltd. , https://www.suscoil.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge> traction motor armature bearing Traction motor armature bearing
The traction motor is the primary equipment in the transmission system of electric locomotives and electric drive diesel locomotives; the armature bearing is one of its primary components. The armature bearing load is large; and the size of the traction motor is affected by the wheel diameter and the inner side of the two wheels. Constraints with the lower limit of the locomotive; therefore, it is necessary to have such a small size and a high limit speed for such bearings. /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
1. The bearing armature of single-side transmission usually adopts double fulcrum support; the output end of the gear is the swimming support; the commutator end is the positioning support. The bearing of the output end is close to the gear; the force is the largest; it is the key in the two bearings of the armature. Bearings. In order to reduce the load; cylindrical roller bearings with inner ring without ribs are usually used. Type NU. The commutator ends are usually cylindrical roller bearings with inner ring and ribs with flat retaining ring. NUP type is also used abroad. Cylindrical roller bearings with single ribs and slanting rings.
2. Bearings with double-side drive when the motor power is large; if the single-side drive is still used, the bearing load at the gear end is too large; it is difficult to select the bearing with additional dynamic load and limit speed to meet the demand; Can use the double side transmission method.
The advantage of the double-side transmission is that the helical gear can be selected; the helix angle of the two gears is flat; the direction of rotation is reversed; then the smoother transmission quality is achieved; no axial load occurs. The bearing suitable for this purpose is the inner ring. Cylindrical roller bearing NU type for ribs; if spur gears are used for double-side transmission; bearings with a certain axial force should be selected; cylindrical roller bearings NJ with single ribs in inner ring are usually used.
Recommend to friends comments close window Bearing related knowledge Knowledge of Rolling Bearings---Capacity Acquisition Knowledge Bearing Heat Treatment Skills and Equipment (3)
Machine tool spindle and bearing vertical with seated self-aligning bearing classification
NTN imported bearings themselves sealing skills
This article links to http://
Please indicate the bearing network http://
Previous:Determining the scale parameters of SKF imported bearings Next: Protection of wheel bearings
Source: China Bearing Network Time: 2013-07-25