Wheel Hub Assembly For JAGUAR,Front Wheel Bearing Assembly,Rear Wheel Bearing Hub Assembly,Hub And Bearing Assembly SHAOXING ZHENGHONG AUTO PARTS CO.LTD , https://www.kontinental-bearing.com
1, pump leakage reasons (1) installation of pumps, water seal seat assembly is not installed in place, causing the pump to continue to leak. As with the hole corresponding to the inspection hole block (rejection) hydrosphere, when the water seal leaks, the cooling water shaft along the water ring will be thrown out from the pump hole and drip, so as to prevent Cooling water flows into the bearing to destroy lubrication. In addition, the replacement of the retaining ring does not pay attention to clear the pump body and the pump cover can not be well combined and sealed, will result in water leakage pump. ⑵ old machines, sealing parts wear, corrosion and aging failure, is also the cause of the pump leaks. When the construction machinery is parked for a long period of time, there is no cooling water in the engine, causing the bakelite gasket to deform due to the dry knot and shrinkage. Although the bakelite gaskets will expand but not fully restore the original shape after the water is added, it will cause a small amount of water leakage. In addition, the newly installed pumps, bakelite gaskets and cast iron bushings have not yet fully run well, will also lead to a small amount of water leakage pump. ⑶ poor working environment of construction machinery, easily lead to uneven wear bushing seals and bushings end surface; spring long-term immersion in the water, easy to rust, decreased elasticity, can also cause water leakage. ⑷ winter forget to put water or water is not clean, and when the water temperature is too high, the cooling system after the condensation of water vapor freezing, are likely to cause pump body was frozen, leading to water leakage. 2, emergency measures If you are working on the engine water pump leakage, shall not immediately stop its work, it should be maintained at the minimum steady speed, while the water inside the cooling system to add water to drain (Note: Open the cap should be Put a cover over it to prevent the steam from being scalded), cool down the engine for a short period of time, and then drive slowly to the nearby shelter for further exclusion. If it is a sudden encounter with the pump casing rupture and leakage, or damage to pump parts and lost pump water role, may be appropriate to replace the relevant parts, troubleshooting. If the pump damage is very serious, the way there is no repair conditions, the pump can be directly connected to the inlet and outlet to take full advantage of the natural circulation of hot and cold water to temporarily maintain the engine to maintain normal temperature; or use a tube or bucket as Container, firmly fixed, and then leads two hoses from the container, one connected to the inlet of the engine, the other connected to the engine outlet, the other end of the two tubes are inserted into the container , And should be fixed hose. If only the pump casing cracks and leaks, cracks can be handled clean, and then use adhesives to make up. In order to emergency, available egg mixture of cement mixed into a sticky group smear in the cracks, to be solidified a few minutes before you can use. Construction machinery driving or work process, the water pump water leaks are also commonplace. As long as there is no rejection of water ring damage or swelling deformation, inadequate spring seal water pressure or broken and other failures, can carry out emergency treatment. Specific measures for emergency response is: If the water seal due to the seal is not strict there is a slight leakage, but the wear is not too serious, you can shop in a glass or flat sand cloth, the sealing surface of water seal grinding can be smooth; Bakelite seal can be flipped before use. However, both should be noted that the water seal and the pump body contact surface should be ground to ensure its sealing performance. Related topics: Broad future of pumps - Asia pump network project planning